300 MHz Filter
Part Number
SF0300BA01973S
Micro Networks Corp., 324 Clark Street,
Worcester, MA 01606, USA tel: 508-852-5400, fax:508-852-8456, www.micronetworks.com
Rev 1.1 26-Apr-02
Page 1 of 2
TYPICAL PERFORMANCE
Horizontal:
2 MHz/div
Vertical (from top):
10 dB/div
1 dB/div
200 ns/div
SPECIFICATION
NOTE All electrical specifications apply at room temperature (23
°C) only.
PARAMETER
Min
Typ
Max
Units
Center Frequency (F
C
)
1
299.935
300.010
300.085
MHz
Insertion Loss
2
15
19
dB
3dB Bandwidth
3 4
3.2
3.3
MHz
40dB Bandwidth
3 4
4.6
4.7
MHz
Ultimate rejection at F
C
+/-(6 to 40) MHz
4
45
50
dB
Average Passband Delay
1.67
1.8
µs
Passband Amplitude Ripple
3 5
0.75
1.0
dB p-p
Passband Group Delay Ripple
3 6
70
200
ns p-p
Passband Phase Linearity
3 6
3
10
deg p-p
Return Loss at Input and Output
3 6
10
dB
Triple Transit Suppression
40
46
dB
Source and Load Impedance
50
Frequency change with Temperature (T
C
20 °C)
-0.009(T-T
C
)
2
kHz /
°C
2
Operating Temperature Range
-30
+70
°C
Storage Temperature Range
-40
+85
°C
Notes:
1. Center frequency is defined as the mean of the upper and lower 3dB points. The typical room temperature center
frequency may be offset from 300 MHz to allow for frequency change with temperature.
2. Measured at the frequency at which the insertion loss is minimum.
3. All bandwidths are centered at F
C
.
4. Decibel level is relative to the insertion loss.
5. Over bandwidth F
C
+/- 1.2 MHz.
6. These parameters to be satisfied over the 3 dB bandwidth.
300 MHz Filter
Part Number
SF0300BA01973S
Micro Networks Corp., 324 Clark Street,
Worcester, MA 01606, USA tel: 508-852-5400, fax:508-852-8456, www.micronetworks.com
Micro Networks Corporation
Worldwide Headquarters: 324 Clark Street Worcester, MA 01606. tel: 508-852-5400 fax: 508-852-8456
European Sales Headquarters: Hertosingel 20 6214 AD Maastricht, Netherlands. tel: +31-43-32-70915 fax: +31-43-32-70715
www.micronetworks.com
Rev 1.1 26-Apr-02
Page 2 of 2
PACKAGE OUTLINE
Units: mm
Pin Configuration:
Input:
10
Input Return:
1
Output:
5
Output Return: 6
Ground:
2,3,4,7,8,9
MATCHING
CIRCUIT
Suggested component values in 50
: Cp1 = 27 pF, Ls1 = 27 + 8.2 nH, Ls2 = 33 nH, Cp2 = 27 pF
Minimum Q of inductors: 45.
Notes -
May require 2% matching components in order to meet return loss specification.
-
Optimum component values can change depending on board layout.
Ls1
Ls2
Cp1
Cp2
10 5
1 6
PDF 
ZIP